Kuppersbusch USA KD 6500.1 User Manual download pdf (Page 10)

10 GB

Active carbon filter

• Operation

The activated charcoal filter is only fitted in recirculation type hoods. It will retain odours

until it becomes saturated. It cannot be washed or regenerated, and must be replaced

when the Filters LED starts, or at least once every 4 months of use. Attention:in

recirculation type hoods the T2 Motor LED may start to flash as well as the Speed + T4

LED. This indicates that as well as replacing the activated charcoal filter, it is also necessary

to perform maintenance operations on the metal grease filters.

• Replacing

Remove the grease filters (fig.10) and take out the activated charcoal filter from its housing,

turning the lugs provided (fig. 11). Insert the new activated charcoal filter and replace the

metal grease filters.

• Enabling the alarm signal

In recirculation type hoods the saturated filters alarm must be enabled as indicated below:

- Turn off the lights and the suction motor;

- Press and hold the T4 button for at least 10 seconds, until the LEDs start to flash. Note

the number of flashes:

- 2 flashes of the LED Activated charcoal filter saturation alarm ENABLED.

- 1 flash of the LED Activated charcoal filter saturation alarm DISABLED;

• Resetting the alarm signal

To turn the alarm signal off, proceed as follows:

- Press the T4 button for at least 3 seconds, until the LEDs flash in confirmation. In any

case the saturated filters alarm will only come into operation when the suction motor is

turned on. WARNING: always comply with the maintenance and replacement times

indicated, in order to avoid a possible risk of fire when the filters are saturated

with grease.

Lighting

• Before attemping to replace the lamps, make sure that the light switch is turned off.

• It consists of 2 20 W-halogen spotlights (60 cm model) and 3 20 W-halogen spotlights

(90 cm model).

• Replacement (fig.12)

Remove the two screws that lock the metal ring, take the spotlight out of its holder by

pulling slightly. When replacing, make sure that both pins are well inserted in the holder

seat.

Cleaning

When cleaning the hood:

- Never use a wet cloth or sponge, or running water.

- Never use thinners or products containing alcohol, as they might damage the paintwork.

- Never use abrasive cleaning materials, in particular when cleaning stainless steel surfaces.

It is recommended to use a damp cloth and mild liquid household cleaner.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Kuppersbusch USA KD 6500.1 User Manual Page 10